Some do a modification with shields behind the antenna to reflect the signal.Ģ2. Booster apps are available to extend the FPV range. Developers are working on a solution but it’s not ready yet.Ģ1. The ‘7th channel’ lever (if you added it) to control tilting the camera down will not work when the app is switched on. If using Windows to upgrade firmware, you have to download the DJI drivers first.Ģ0. And everyone will tell you something different. There are lots of opinions on using the latest firmware. A little electrical tape to shield the lens often helps. Flickering in video may be caused by the props creating shadows. Standard props and batteries are good.ġ7. U se of prop guards, as these are almost universally accepted to enhance a wobbling state when hovering or descending called Vortex Ring State (Google it). It will hover above the home point until you regain control by flicking S1 to ATTI and back again.ġ5. The aircraft will complete its waypoint mission even if the transmitter is turned off. If there is a tree or a building on that travel route, the aircraft WILL hit it.ġ4. Imagine a wire stretched between the waypoints that you have added. When using waypoints, the craft will fly from the ground to the first waypoint altitude gradually. If there are buildings or trees in the way when flying at this elevation on Return to Home, the aircraft WILL hit them.ġ3. It is either current elevation OR 20m (66feet) whichever is highest. You cannot adjust the Return to Home height. Learn to be more gentle with the controls.ġ2. You cannot turn down the yaw sensitivity. Let it sit and hover for a while to make sure it responds to all of the controls.ġ1. When taking off from the ground give it full throttle and release when it gets up a few feet. If you lose satellites when in flight, the craft will enter ATTI mode and MAY get blown away. The number of satellites indicated on the app will turn blue.ĩ. This is the second set of rapidly flashing green lights. Do not take off until you have home point recorded. Leave it there for three or four days before attempting to turn it back on.Ĩ. Use a hair drier liberally and then put everything in a sealed container and cover it in uncooked rice. If you dunk your V+ in fresh water, get it out as quickly as possible and take it apart. Little apart from the plastic is worth saving.ħ. If you dunk your V+ in sea water throw it away. The camera is NOT replaceable with a GoPro.Ħ. If you remove the camera/gimbal, you will not be able to see anything in the app.ĥ. If the gimbal is off level slightly, a full IMU recalibration in the software assistant may cure it.Ĥ. If your gimbal is shaking and vibrating or off the level, you may be able to repair it following the advice here viewtopic.php?f=27&t=19653&hilit=solvedģ. You CANNOT substitute a GoPro camera with a Zenmuse. If you’ve crashed it and bent the gimbal or tore the little black ribbon cable, you can only send it back to DJI for repair or buy a new camera/gimbal combination. It'll save you going through pages and pages.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |